Jeanneau Selection 37 complete renovation
Hello everyone,
I am after complete renovation of my Jeanneau Selection 37 and I am going to share details on the renovation process here. I believe it will be useful for the members of the forum.
It has been striped all over and a two layers of epoxy primer already have been applied. The rudder has been removed, it was very stuck, and the engine has been maintained, now it starts in a turn. The propeller shaft has been already removed as well for inspection. The superstructure of the keel has been reassured because of the additional lead ballast which will be put on it later on.
What I need now is to replace the rubber sealing of the propeller shaft, the lower sealing of the rudder and the sealing of the propeller shaft stand (holder).
Any information about how to get the parts needed is highly appreciated.
Hi ,
If you check on this forum , you will see many posts on the selection 37.
I did use a rubber sealing like the one on the picture. I didn't like it. On my new vessel , l use a Volvo type witch is so far very good after 800 h on the engine.
Hello,
I have this one, seems in order...
www.svb-marine.fr[...]ss.html